Hi QM Guru,
I did maintain inspection type 10 in this material but while i would like to create the inspection lot manually.
I try to create manual inspection lot manually , i encounter this error with Inspection lot origin 89.
----------------------------------------------------------------------------------------------------------------------------------------------------
No valid inspection type for material 10000037 was found or selected
Message no. QA280
Diagnosis
An active inspection type for the material 1XXXXXXX in plant XXXX could not be found for the specified origin 89 or none of the available inspection types was selected.
System Response
Inspection lots cannot be created.
Procedure
Check the inspection type setting in the material master.
Is there anything which i missing ?
Thank you.