My current configuration for notification creation is one notification for one Lot . When ever the spec is out of the tolerance limit a defect needs to be logged an auto notification for an inspection lot is created . When I went back to the same result and update the result to good then defect needs to be removed and the notification needs to be marked and completed and Deleted (NOCO DLFL) .
In the same inspection point when ever there is a another Bad result then it should reopen the same notification and add the defects in to the same notification which is not happening now .
I looked into the configuration but I didn't find any clue.I am not sure is there any enhancement that is stopping this to happen. Can anyone help me where I need to start looking at for this issue ? .
Thanks & Regards
Suman