Hi Gurus,
We're in process of implementing QM process for gas tanks that are used in test equipment to measure the air pollutants. Some of the tanks contain number of gases such as SO2 and CO.
Each tank must be inspected 3 times in 2 months intervals to ensure that the concentration level stays within the standard deviation. If the tank passes the 3 inspections, it can then be used in test equipment. If tank fails the 1st time, it is sent back to the manufacturer. The gas tank are also serial numbers and tracked individually.
I would like your input on the followings:
1. How would I capture the gases in tank so I could do inspection on the their level of concentration. For example if a tank contains 3 gases, should they be characteristics on the material master or should they be treated as BOM item (the BOM header being gas tank).
2. In regard to the # of inspections (3 times every 2 months), how can I achieve this so the gas tanks go through the inspection at least 3 times before being released for use.
Thank you.