When I used sampling procedure in the inspection plan for some MICs, if I need to setup sampling procedure for every single characteristic?

Hi Gurus,

When I use sampling procedure to calculate the sample size,

e.g. inspection plan has 3 MICs,

First MIC used sampling procedure, size is 1 KG,

Second used sampling procedure, size is 5 KG,

Third does not use sampling procedure. And nowhere to setup the sample size for this MIC.

When I generate the Insp. Lot for 100 KG. The sample size is 100 KG. Not 5KG as expected.

If I also setup sampling procedure for third MIC, the calculation works fine.

When I used sampling procedure in the inspection plan for some MICs, if I need to setup sampling procedure for every single characteristic?

• And What mean of this saying in SAP help?  “For the characteristics without sampling procedures, the sample size is based on the unit of measurement defined in the material master (1 kilogram in this example).”
• http://help.sap.com/saphelp_470/helpdata/en/2d/351a0c448c11d189420000e829fbbd/content.htm

Thanks,

Stanley.